![]() ![]() That being said if you have an old pc around it may be worth some small effort to get a NAS built on it. The above process I am using in a lab environment for testing new or unfamiliar Synology apps without disturbing my production unit. In summary for production environments I have been recommending and using Synology hardware with with official DSM software. ![]() DSM running on Dell hardware Synology DSM install on a PC Summary When done you should now be able to open a web browser and using the IP address you found above open up the login screen as shown below. See the link above to confirm if you are using the correct versions. If this is the case then you either have the wrong loader or wrong. I have noticed that if it fails it will be around the 55-56% mark. When asked if you would like to have the software auto update you must choose the option of notify only as it is very possible that an auto update will break the install. It should take about 10 minutes to install the software successfully. The install screen will look similar to the above image. If found click on the device to bring up the initial screen to install the DSM software you download from the previous step. If your device is not listed check to make sure it is power on and connected to your network. At this point it should find the PC on the network waiting for you to install the DSM software. Open the software and click the search button. This can be done with the Synology Assistant software that is available to download from the Synology website. The next step is to find the Synology NAS on the network. The link I use was Step6 – Find your NAS on the network This file should be just over 350MB in size. It should boot to a point where you now find the Synology NAS device using the Synology Assistant./rploader.sh build broadwellnk-7.1.0-42661Įxitcheck.sh reboot Step5 – Download the Synology PAT file When done with build command run the second command to reboot the device. To build the loader run the below commands in the terminal window. The next step to get Synology DSM installed is to build the loader. To get the IP address run the below command in the terminal window. I also need the IP address of the pc in order to connect to it later. rploader.sh serialgen DS3622xs+ realmacĪnswer Y to any questions asked during the process. In the same terminal windows run the below commands./rploader.sh identifyusb Next are commands that Configure System-Specific Parameters for the devices. To do so please run these commands from the terminal window./rploader.sh updateĪfter a few moments it will finish the upgrade. Next step is to run some terminal commands to update and upgrade the Tin圜ore installation. You will need to run a few commands in the terminal window. You can then click the terminal icon in the task bar area to open up a terminal session. After successfully booting you can login with the username: tc and password: all worked well so far you should see the GUI for Tin圜ore. Depending on the pc hardware you may need to change a setting your bios to allow the device to boot from a USB device. Next it to boot the pc you will use as your NAS from the USB stick created with Rufus. Note to burn the correct file you must unzip the tinycore-redpill.v0.8.0.0.img.gz to get to the img file. Rufus is a very good utility that will burn img or iso files to disks. There is also a good chart on the below page that lists what versions should work with which hardware.īurn IMG file to USB stick using Rufus. The version I used was tinycore-redpill.v0.8.0.0.img.gz. Steps to Get DSM running on a PC Step1 – Download Tinycore-redpill There are many versions of DSM available depending on your NAS model from the Synology Download center. From : Synology DiskStation Manager (DSM) is the intuitive operating system that powers every Synology NAS. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |